Welcome to EPDM Coatings Q&A, where you can ask questions and receive answers.
0 votes
First applied Proflex primer, set and was tacky, then mixed and immediately started installation. From the start the Liquid roof was super hard to roll.  So hard that it would pull my roller off and could barely move with squeegee. I finished and had tiny bubbles everywhere. All those bubbles popped after about 8 hours and now I have tiny craters all over the roof.  Is this normal? Was there something that went wrong with the mixing?  All the videos I watched didn't seem to have the same issue as I did.  It was early in the morning at 78 degrees.

 

Thanks
in Liquid RV Roof Magic by

1 Answer

0 votes
yes these bubbles are normal that is part of the curing process the thicker it was applied the more bubbles you will see but they will reduce in size.  Some of the videos on our site show the bubbles and how they reduce in size after 2-3 weeks thank you
by
...