Welcome to EPDM Coatings Q&A, where you can ask questions and receive answers.

Type in your question and our database will help you find the answer

Related questions

Is RVroofmagic compatible with Royal Roof tm. EPDM rubber sheet?

0 votes
Is RVroofmagic compatible with Royal Roof tm. EPDM rubber sheet? It is on a 1999 Forest River Wildwood 25' 5th wheel. I called Rorest river they told me it was a EPDM rubber roof. Also wanting to find out correct way to prep, 4" Eternalbound seam tape that I used to repair small tears on edges. I understand it needs to be sanded and contact cement coated. would sanding and then coating with proflex primer work ? Or would I need to sand ,contact cement then proflex prime ?
asked Jun 10, 2018 in Liquid RV Roof Magic by Allen C.
edited Jun 10, 2021 by admin

1 Answer

0 votes
No primer is needed just a flash coat then a final coat

 

see below

If you have an existing epdm roof, it is important for you apply a very light coat (a flash coat, approximately 4 mil or the thickness of 2 pieces of paper). Failure to do so will result in swelling of the membrane which will require additional days for the product to settle. The final coat will be at a 16 mil thickness. Divide the length of your rv by the number of remaining gallons, this number will tell you the length of the sections needed for each gallon. For example, if your trailer is 24 feet long, you will need 4 gallons. One gallon will be for your flash coat. The remaining three gallons will be for the final coat. After your flash coat, divide your 24 ft long trailer by 3 (the number of remaining gallons) resulting in eight-foot-long sections. Each of your remaining gallons will cover one of these 8 ft section.

Thank you
answered Jun 11, 2018 by admin
edited Jun 10, 2021 by admin
...