Welcome to EPDM Coatings Q&A, where you can ask questions and receive answers.

Related questions

0 votes
1 answer 421 views
0 votes
2 answers 843 views
0 votes
Is  RVrroofmagic compatible with Royal Roof tm.  EPDM rubber sheet? It is on a 1999 Forest River Wildwood 25' 5th wheel. I called Rorest river they told me it was a EPDM rubber roof. Also wanting to find out correct way to prep, 4" Eternalbond  seam tape that I used to repair small tears on edges. I understand it needs to be sanded and coated with contact cement , would sanding and then coating with proflex primer work ? Or would I need to sand ,contact cement then proflex prime ?
in Liquid RV Roof Magic by
edited by

1 Answer

0 votes
correct sand cement then apply.  if you have an existing epdm rubber roof then you can simply coat over that with the RVroofmagic. There is no primer needed

 

see below

If you have an existing epdm roof, it is important for you apply a very light coat (a flash coat, approximately 4 mil or the thickness of 2 pieces of paper). Failure to do so will result in swelling of the membrane which will require additional days for the product to settle. The final coat will be at a 16 mil thickness. Divide the length of your rv by the number of remaining gallons, this number will tell you the length of the sections needed for each gallon. For example, if your trailer is 24 feet long, you will need 4 gallons. One gallon will be for your flash coat. The remaining three gallons will be for the final coat. After your flash coat, divide your 24 ft long tailer by 3 (the number of remaining gallons) resulting in eight-foot-long sections. Each of your remaining gallons will cover one of these 8 ft section.

Thank you
by
edited by
...